ABB PSTX Series Installation And Commissioning Manual page 15

2.3 How to start/stop the motor
WARNING
Dangerous voltage: Can cause death or serious
injury. Always set the power switch to off and lock
out all power to this device before you start to
work on the equipment.
WARNING
Approved personnel are allowed to install and
make the electrical connection of the Softstarter
in accordance with existing laws and regulations.
WARNING!
Before you connect the Softstarters PSTX30...
PSTX170 to the operation voltage for the first time,
apply control supply voltage to open the bypass
relays. (see 2.1 Connection). This is necessary to
avoid an accidental start of the equipment while it is
connected to operation voltage.
INFORMATION
ABB personnel must obey the instructions in
ABB CISE 15.4.
1. Set the operation voltage switch to ON.
2. To start the Softstarter from the keypad, push
the R/L-key to select local control, then push the
Start key on the keypad. Push Stop to stop the
Softstarter
3. To start from hard wire control, push the R/L-key
to select hard wire control, then push the remote
Start key. Push Stop to stop the Softstarter.
1SFC132081M0201 | Installation and commissioning manual | Quick start
2
15