5
PRE-OPERATION PROCEDURES
5.5.2
Switch setting for the intelligent function module
In the intelligent function module switch setting for the EtherNet/IP module, hardware test
and self-loopback test can be set.
No setting is required when not using the hardware test and self-loopback test.
For details of the hardware and self-loop back test, refer to the following.
Section 5.6.1 Hardware test
Section 5.6.2 Self-loopback test
Figure 5.15 "Switch Setting for I/O and Intelligent Function Module"
Table 5.9 Setting items in "Switch Setting for I/O and Intelligent Function Module"
Item
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
1) Configure the settings on "I/O Assignment" of GX Works2.
(
Section 5.5.1 Intelligent function module detailed setting)
Figure 5.14 "I/O Assignment"
2) Clicking
Switch Setting
Function Module" window.
Refer to the following and complete the setting.
Set the hardware test or self-loopback test.
No settings (blank): Online mode (default)
000D
: Hardware test
H
000E
: Self-loopback test
H
No settings (blank)
When any item is set, delete the settings and leave the field blank.
3) When the setting is completed, click
5.5.2 Switch setting for the intelligent function module
displays the "Switch Setting for I/O and Intelligent
Description
.
End
5.5 Setting from GX Works2
1
2
3
4
5
6
Select "HEX".
7
8
5
- 16