Mitsubishi Electric MELSEC Q Series User Manual page 173

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
(2) Display and settings of the "Message Tag" window
Item
Nic Select an Own Nic No.
Connection Type Select "Class3" or "UCMM".
Select the Class3/UCMM Tag communications type.
•"Originator Read": Requests reading to the Tag of the connected device. (Tag data reading)
Setting Type •"Originator Write": Requests writing to the Tag of the connected device. (Tag data writing)
•"Target Read": Receives a reading request from the connected device.
•"Target Write": Receives a writing request from the connected device.
Set the tag name.
Tag Name
Up to 100 one-byte alphanumeric characters can be used.
GX Works2 Label When the "Label (for GX Works2) Setting Enable" checkbox in the "Add Own Nic" window is selected, the Tag name
Name set in "Tag Name" is automatically used as it is.
Select one from the following.
•"INT": 1 word
Data Type
•"DINT": 2 words
•Data Type name registered in the "User Define" window (
Set the data size of the Tag.
Data Size When selecting a Data Type name that has been registered in "Data Type" of the "User Define" window, the size of the
selected Data Type is automatically set.
Select the Node Name of the connected device when selecting "Originator Read" or "Originator Write" in "Setting
Remote Node
Type".
Set the Remote Tag name of the communication destination when selecting "Originator Read" or "Originator Write" in
"Setting Type".
Remote Tag
Up to 100 one-byte alphanumeric characters can be used.
Figure 7.27 "Message Tag" window
Table 7.21 "Message Tag" window settings
Description
7.9 "Setting" Tab (Parameter Settings)
*1
(Up to 32 alphanumeric characters when using a label)
Section 7.9.5 "User Define" window)
*1
7.9.4 "Message" window
1
2
3
4
5
6
7
8
7
- 46