Mitsubishi Electric MELSEC Q Series User Manual page 189

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
(1) "Producer" window
Item
/ button
Start Monitoring Stop Monitoring
Monitoring/Stop
Tag status monitor
Nic No.
Tag Name
State
Size
Target IP
Connection ID
Tag Data View
HEX/DEC/BIN/ASCII/
ASCII(SWAP)
Figure 7.35 "Producer" window
Table 7.30 "Producer" window items
Monitoring is started or stopped in the "Producer" window.
The monitoring status is displayed.
•"Monitoring ● (green)": Monitoring
•"Stop ● (red)": Monitoring stopped
The status of the Producer Tag that has been registered in the EtherNet/IP module is displayed.
Nic No. is displayed.
The Tag name that has been configured in the EtherNet/IP module is displayed.
The status of the Tag is displayed.
•● (green): Normal communications
•● (red): Abnormal communications
The size of the Tag is displayed.
The IP address on the Consumer side is displayed.
The connection ID for the connected device with the requested Tag is displayed.
•Blank when Tag communication start process completion (X00) is not on.
•"00000000h" is displayed when there has not been a single normal communication since Tag
communication start process completion (X00) was turned on.
The data of the selected Producer are displayed in the format selected below.
Select the display format of "Tag Data View".
•When ASCII is selected, data except 20
When the selected Tag is of the Data Type that has been registered in the "User Define" window,
data are displayed as the configured Data Type. (
the "User Define" window)
When "Unit" of Define is "BIT", data are displayed as shown below.
•When "HEX", "DEC", or "BIN" is selected, data are displayed as "ON" or "OFF".
•When "ASCII" or "ASCII (SWAP)" is selected, data are displayed as ".".
7.11 "Monitoring" tab (Network Diagnostics)
Description
to 7F are displayed as ".".
H H
Section 7.9.5 (1) Display and settings of
1
2
3
4
5
6
7
8
7
- 62