How To Use The Selection Tree - Mitsubishi Electric MELSEC Q Series User Manual

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
7.5.2

How to use the selection tree

The EtherNet/IP module information that has been configured in Utility Package (start I/O
No. and IP address) is displayed.
Also, settings common to all modules are configured and a PING test is conducted.
The operations of the selection tree are listed in the following table.
Item
Project
Nic1 Setting
Start I/O No.:
IP Address:
Nic2 Setting
Nic3 Setting
Nic4 Setting
RPI Set
Refresh Parameter
Ping Test
Figure 7.10 Selection tree
Table 7.8 Description of the Selection tree
Displays a project name.
Displays the information of the first EtherNet/IP module.
It is displayed when [Own Nic] is configured in the "Basic" window on the
"Setting" tab.
Displays the Start I/O No. set for the project.
Displays the IP address set for the project.
Displays the information of the second to fourth EtherNet/IP modules.
The operations and functions are same as those of "NIC1 Setting".
Double-clicking the item displays the "RPI Set" window.
Double-clicking the item displays the "Refresh Parameter" window.
Double-clicking the item displays the "Ping Test" window.
Description
7.5 Window Structure
7.5.2 How to use the selection tree
1
2
3
4
Reference section
-
-
Section 7.9.1
5
Section 7.9.1
-
-
-
Section 7.9.6
Section 7.9.7
Section 5.8
6
7
8
7
- 20