Mitsubishi Electric MELSEC Q Series User Manual page 159

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
Item
[Own Nic]
Nic No.
Start I/O No.
Nic Name
IP Address
button
Remove
Apply button
[Remote Nic]
Node Name
Nic No.
IP Address
Add button
Remove button
Apply button
Table 7.14 "Basic" window settings
Add the EtherNet/IP module information to the project and edit it.
Double-click the cell to add and edit the information. (
window in this section)
The numbers for distinguishing the settings by module are displayed. (Arbitrary settings cannot be
made.)
The start I/O No. configured in the "Add Own Nic" window is displayed.
The Nic Name configured in the "Add Own Nic" window is displayed.
The IP address configured in the "Add Own Nic" window is displayed.
Clicking this button after selecting a registered cell will remove the selected row.
When this button is clicked, the window for selecting the buttons below will appear.
• button: Applies the settings made with [Own Nic] to Utility Package and writes
Download Parameter
them in the EtherNet/IP module along with other parameters that have been set with Utility Package.
• button: Applies the settings made with "[Own Nic]" only to Utility Package.
Only Apply
Register the information of the connected device in the project. Up to 256 information settings of the
connected device can be configured.
Set the name of the connected device. (Up to 40 one-byte alphanumeric characters)
Enter the Nic No. of the EtherNet/IP module to communicate with the connected device from "[Own Nic]".
Enter the IP address of the connected device.
When this button is clicked after a cell is selected, a setting item row will be added below it.
Clicking this button after selecting a registered cell will remove the selected row.
The items set with "[Remote Nic]" are applied to Utility Package.
Description
(1) Display and settings of the "Add Own Nic"
7.9 "Setting" Tab (Parameter Settings)
7.9.1 "Basic" window
1
2
3
4
5
6
7
8
7
- 32