Mitsubishi Electric MELSEC Q Series User Manual page 101

4
FUNCTION
(3) Checking the acquired parameters
Acquired parameters can be checked on the "Main" tab in Utility Package.
(
POINT
Section 7.6 "Main" Tab (Module Status Display))
(1) "Not Use" is recommended for the DHCP client function.
To enable the DHCP client function, configure the DHCP server appropriately
so that the same IP address is always allocated to the EtherNet/IP module.
When the IP address is changed, the IP address must be reconfigured using
"[Remote Nic]" in the "Basic" window.
(2) The parameters not specified by the DHCP server are set as the default
values of the EtherNet/IP module.
( Section 7.11 (4) "Connection" window)
4.5 DHCP Client Function
1
2
3
4
5
6
7
8
4
- 25