Writing Parameters To The Ethernet/Ip Module - Mitsubishi Electric MELSEC Q Series User Manual

7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
7.10.2

Writing parameters to the EtherNet/IP module

Write the set parameters to the EtherNet/IP module.
(1) Displaying the "Download Parameter" window
(2) "Download Parameter" window and setting description
Item
PLC Type
PC I/F
Nic No.1 to 4 Start I/O No.
Click [Online] [Download Parameter].
"Transfer Setup" window will be displayed if the above operation is performed without
setting the connected EtherNet/IP module.
Refer to the following and complete the setting.
Section 7.10.1 Configuring the EtherNet/IP module
Figure 7.32 "Download Parameter" window
Table 7.27 Description of the "Download Parameter" window
Displays the QCPU set on the "Transfer Setup" window.
Displays the connection interface set on the "PC side I/F Setting" window.
Displays the start I/O No. of the EtherNet/IP module at connection destination.
7.10.2 Writing parameters to the EtherNet/IP module
Description
Reference
section
Section 7.10.1
(2)
Section 7.10.1
(2)
Section 7.9.1
(1)
7
7.10 Online
- 56
1
2
3
4
5
6
7
8