Mitsubishi Electric Melsec Q Series User Manual page 96

3
SPECIFICATIONS
(1) Control master FDL address display area (Un\G2263)
(2) Standby master FDL address display area (Un\G2264)
3
- 55 3.4 Buffer Memory
3.4.14 Redundant system area
This area stores the FDL address of the control system QJ71PB92V when it is used in
a redundant system.
The FDL address is stored when the Communication READY signal (X1B) turns ON.
The FDL addresses for the control system are set in GX Configurator-DP.
( Section 6.3)
Table3.21 Control Master FDL Address Display Area (Un\G2263)
Set Value
0000 to 007D
H H
(0 to 125)
FFFF
H
This area stores the FDL address of the standby system QJ71PB92V when it is used
in a redundant system.
The FDL address is stored when the Communication READY signal (X1B) turns ON.
The FDL addresses for the standby system are set in the Intelligent function module
switch setting of GX Works2. (
Table3.22 Standby Master FDL Address Display Area (Un\G2264)
Set Value
0000 to 007D
H H
(0 to 125)
FFFF
H
The FDL address of the QJ71PB92V in the control system
• Parameter not registered
• The QJ71PB92V is not mounted to a redundant system.
Section 6.7)
The FDL address of the QJ71PB92V in the standby system
• Parameter not registered
• The QJ71PB92V is not mounted to a redundant system.
Description
Description