Mitsubishi Electric Melsec Q Series User Manual page 150

4
FUNCTIONS
(3) Procedures before system operation
Replace the QJ71PB92D mounted on the base unit with the
QJ71PB92V.
Turn on the power.
Enable the QJ71PB92D-compatible function with GX Works2,
and write PLC parameters to the QCPU.
Reset the QCPU.
QJ71PB92D-compatible function enabled?
(£
Perform self-diagnostics on the QJ71PB92V.
In GX Configurator-DP, set the PROFIBUS-DP parameters.
Select QJ71PB92D as the module for the GX Configurator-DP
project.
setting for the case of a CPU stop error?
Set the output status setting for the case of a CPU stop error by
GX Works2 and write the PLC parameters to the QCPU.
Reset the QCPU.
4
- 41 4.9 QJ71PB92D-Compatible Function
In the Intelligent function module switch setting, enable the QJ71PB92D-compatible
function.
The following shows how to enable the QJ71PB92D-compatible function.
Start
Is the
(4) in this section
)
Yes
Use output status
Yes
1)
Figure 4.33 Procedures before System Operation
Steps shown in are the same as those for the QJ71PB92D.
¢PROFIBUS-DP Interface Module User's Manual
(5.1 Procedures before Operation)
Section 6.7
£
No (Check the parameter settings.)
(5) in this section
£
No
2)