Toro Reelmaster 3100-D Service Manual page 330

CAUTION
Use the 1−3/8" flats on the input shaft to prevent
the input shaft from rotating during adapter in-
stallation. DO NOT use the 1/2" hex on the input
shaft to secure the shaft during adapter installa-
tion or input shaft damage may occur.
10.If removed, install the threaded adapter in the input
shaft. If reusing a previously installed threaded adapter,
apply medium strength thread locker to the smaller
(5/8−11) threads only. Tighten threaded adapter from
115−125 ft−lb (156−196 N−m).
11. Operate groomer gear box by hand to check for
proper operation prior ro installation.
Installation (Fig. 2)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
CAUTION
Contact with the reel or other cutting unit parts
can result in personal injury. Use heavy gloves
when handling the cutting reel.
2. Safely prevent reel from rotating by blocking the cut-
ting reel with piece of wood near one of the reel spiders.
IMPORTANT: Groomer gear boxes installed on the
left side of the cutting unit use a left hand thread.
Turn the input shaft (rear roller brush drive shaft)
counterclockwise to install the gear box. Groomer
gear boxes installed on the right side of the cutting
unit use a right hand thread. Turn the input shaft
clockwise to install the gear box.
3. To attach the gear box to the cutting unit:
A. Turn the input shaft in the correct direction until it
is seated against the reel.
B. Use a new cotter pin and install the cotter pin and
clevis pin securing the height adjustment rod to the
front of the groomer gear box.
C. Tighten the input shaft from 90 to 100 ft−lb (122
to 153 N−m).
4. Install the rear roller brush drive shield if previously
removed.
Universal Groomer (Optional)
NOTE: If cutting unit is equipped with an optional pow-
ered rear roller brush, install the rear roller brush drive
housing assembly, drive belt and cover (see Roller
Brush (Optional) in Chapter 8 − Cutting Units in this
manual for additional information).
5. Install the groomer reel assembly (see Groomer reel
in this ).
Page 9 − 10 Reelmaster 3100−D