Toro Reelmaster 3100-D Service Manual page 155

Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove hydraulic cylinder from the frame using Fig-
ure 68 as guide.
2. If hydraulic fittings are to be removed from cylinder,
mark fitting orientation to allow correct assembly.
Installation
1. If hydraulic fittings were removed, install fittings to
cylinder using marks made during the removal process
to properly orientate fittings.
2. Install hydraulic cylinder to the frame using Figure 68
as guide.
3. Adjust scissors mount as follows:
A. Shift sidewinder fully to the left (fully retract cylin-
der).
B. Loosen four cap screws securing mount to lower
frame.
C. The gap between the scissor frame and lower
frame and the gap between the scissor frame and
the sidewinder carrier must be equal distances with-
in 0.060 inch (1.5 mm).
D. Tighten four cap screws and lock nuts.
Reelmaster 3100−D
2
1. Scissor frame
2. Lower frame
Page 4 − 103
4
3
1
Figure 69
3. Sidewinder carrier
4. Gaps
Hydraulic System