Specifications - Toro Reelmaster 3100-D Service Manual

Specifications

Frame Construction: Precision machined die cast alu-
minum cross member with bolt−on cast ductile iron or
aluminum side plates.
Reel Construction: Reels are 27 inches (69 cm) or 32
inches (81 cm) in length and 7 inch (18 cm) in diameter.
High strength, low alloy steel blades are thru hardened
and impact resistant. 27 inch reels are available in 5, 8
and 11 blade configurations. 32 inch reels have 8
blades.
Reel Bearings:
Cutting units with painted side plates have two
double row, self−aligning ball bearings press fit onto
reel shaft with inboard seal for protection. Reel bear-
ing adjustment is maintained by an adjuster nut in the
left side plate of the cutting unit.
Cutting units with aluminum side plates have two
stainless steel sealed radial ball bearings pressed
onto the reel shaft. Reel end play is maintained by an
internal wave spring (no adjustment required).
Reel Drive: The reel weldment shaft is a 1 5/16 inch
(33.3 mm) diameter tube with drive inserts threaded into
both ends. The reel drive inserts have an internal nine
(9) tooth spline.
Height−of−Cut (HOC): Cutting height is adjusted on
the front roller by two (2) vertical screws. Effective HOC
may vary depending on turf conditions, type of bedknife,
roller type and installed attachments.
DPA Cutting Units
Figure 1
Bedknife: Replaceable, single edged, high carbon
steel bedknife is fastened to a machined cast iron bed-
bar with screws. Optional bedknives are available.
Bedknife Adjustment: Dual screw adjustment to the
reel; detents corresponding to 0.0009 inch (0.023 mm)
bedknife movement for each indexed position.
Front and Rear Rollers: Greaseable through−shaft
front and rear rollers are used with these cutting units.
All rollers use the same heavy duty, stainless steel ball
bearings and seal package.
Counterbalance Weight: A cast iron weight or a
groomer and/or a powered rear roller brush accessory
is mounted opposite to the hydraulic drive motor to bal-
ance the cutting unit.
Cutting Unit Weight:
27" Reel, 5 Blade
27" Reel, 8 Blade
27" Reel, 11 Blade
32" Reel, 8 Blade
Options:
Refer to Cutting Unit Parts Catalog for available options
for your Reelmaster DPA cutting unit.
Page 8 − 2
148 lb. (67 kg)
153 lb. (69 kg)
167 lb. (76 kg)
158 lb. (72 kg)
Reelmaster 3100−D