Cutting Unit Removal And Installation - Toro Reelmaster 3100-D Service Manual

Cutting Unit Removal and Installation

Removal
1. Position machine on a clean, level surface. Lower
cutting units, stop engine, engage parking brake, and
remove key from the ignition switch.
2. On the front cutting units, detach chain from the cut-
ting unit carrier frame by removing the lock nut and cap
screw (Fig. 23).
3. Remove hydraulic motor from the cutting unit (see
Reel Motor Removal).
4. Remove lynch pin from pivot shaft (Fig. 24 and 25).
5. Slide cutting unit carrier frame and thrust washer
from the pivot shaft.
Installation
1. On the front cutting units, slide thrust washer and
then cutting unit carrier frame onto pivot shaft (Fig. 24).
2. On the rear cutting unit, slide cutting unit carrier
frame and then thrust washer onto pivot shaft (Fig. 25).
3. Install lynch pin onto the pivot shaft (Fig. 24 and 25).
4. Install hydraulic motor to the cutting unit (see Reel
Motor Installation).
5. On front cutting units, attach chain to the cutting unit
carrier frame with cap screw and lock nut (Fig. 23).
Figure 22
Reelmaster 3100−D
1
1. Chain
2. Cap screw & lock nut
2
1. Lynch pin
2. Thrust washer
1. Lynch pin
2. Thrust washer
IMPORTANT: Make sure hoses are free of twists and
sharp bends. Route rear cutting unit hoses as
shown (Fig. 22). Raise cutting units and shift them
to the left (Model 03201 only). Rear cutting unit
hoses must not contact the traction cable bracket.
If required, reposition fittings and hoses.
Page 7 − 15
2
3
Figure 23
3. Front carrier frame (RH)
4
1
Figure 24
3. Pivot shaft
4. Front unit carrier frame
4
1
3
2
Figure 25
3. Pivot shaft
4. Rear unit carrier frame
SPA Cutting Units
3