Toro Reelmaster 3100-D Service Manual page 257

Bedbar Installation (Fig. 27)
1. Inspect flanged bushings and bushing for wear; re-
place if necessary.
2. Clean and apply anti−seize lubricant to both bedbar
pivots. Install bedbar washer on the bedbar.
3. Install bedbar adjusting housing and bedbar housing
on the bed bar. Reinstall spacer, flat washer, lock wash-
er, and cap screw on the bedbar.
4. Install bedbar assembly on the cutting unit.
5. Secure bedbar housing to the cutting unit with both
carriage bolts and nuts.
6. Secure adjusting housing to the cutting unit with both
carriage bolts and nuts (Fig. 28).
7. Tighten both adjusting lock nuts on the adjusting
housing (Fig. 28).
8. Position bedbar fitting to the bedbar yoke. Screw ad-
justing handle (left−hand threaded) until the bedbar fit-
ting is snug against the bedbar yoke.
Reelmaster 3100−D
1. Adjusting lock nut
2. Adjusting housing
9. Adjust bedknife to reel (see Bedknife to Parallel to
Reel Adjustment).
Page 7 − 19
2
3
Figure 28
3. Carriage bolt and nut
SPA Cutting Units
1