Toro Reelmaster 3100-D Service Manual page 137

Removal
WARNING
Before disconnecting or performing any work
on the hydraulic system, all pressure in the
system must be relieved. See Relieving Hy-
draulic System Pressure in the General Infor-
mation section.
1. Remove control valve from the frame using Figures
54 and 55 as guides.
2. If hydraulic fittings are to be removed from control
valve, mark fitting orientation to allow correct assembly.
Installation
1. If hydraulic fittings were removed, install fittings to
control valve using marks made during the removal pro-
cess to properly orientate fittings.
2. Install control valve to the frame using Figures 54
and 55 as guides.
Reelmaster 3100−D
2
1. Spool Valve
2. Magnet support bracket
Page 4 − 85
1
4
3
Figure 55
3. Flange head screws
4. Frame
Hydraulic System