Toro Reelmaster 3100-D Service Manual page 23

Cutting Units
Each cutting unit has (6) grease fittings (with optional
front roller installed) that must be lubricated regularly
with No. 2 General Purpose Lithium Base Grease.
The grease fitting locations and quantities areas follows:
Bedknife adjuster (2), every 50 hours (Fig. 17); Reel
bearings (2) and front and rear rollers (2 ea.) (Fig. 16).
Note: Lubricate only one reel bearing grease fitting on
each end of cutting unit.
IMPORTANT: Lubricating cutting units immediately
after washing. This helps to purge water out of bear-
ings and increases bearing life.
1. Wipe each grease fitting with a clean rag.
IMPORTANT: Do not apply too much pressure or
grease seals will be permanently damaged.
2. Apply grease until pressure is felt against handle.
3. Wipe excess grease away.
Reelmaster 3100−D
Grease every 50 operating hours.
Grease every 8 operating hours.
Product Records and Maintenance
Page 2 − 9
Figure 17
Figure 18