Toro Reelmaster 3100-D Service Manual page 301

27 to 33 ft−lb 15 to 19 ft−lb
(37 to 44 N−m) (20 to 25 N−m)
7
4
12
10
27 to 33 ft−lb
(37 to 44 N−m)
1. Frame
2. LH side plate
3. RH side plate
4. Shoulder bolt (6)
Reel Assembly Removal
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine and place
on a flat work area.
CAUTION
Contact with the reel, bedknife or other cutting
unit parts can result in personal injury. Use
heavy gloves when removing the cutting reel.
Reelmaster 3100−D
3
6
11
10
Figure 37
5. Rear grass shield
6. Flange nut (6)
7. Special screw
8. Flat washer
Page 8 − 31
5
1
6
12
27 to 33 ft−lb
(37 to 44 N−m)
9. Cap screw
10. Washer (2)
11. Support rod
12. Flange head screw (2)
3. If cutting unit is equipped with a counterweight or ac-
cessory on LH side plate, remove the counter weight or
accessory from the cutting unit. Remove and discard
O−ring from counter weight. See Chapter 9 − Universal
Groomer in this manual for additional Groomer informa-
tion. See Rear Roller Brush in this chapter for informa-
tion on rear roller brush.
4. Remove bedbar assembly (see Bedbar Assembly
Removal in this chapter).
5. Remove front and rear rollers (see Front Roller Re-
moval and Rear Roller Removal in this chapter).
6. Remove cap screw and flat washer that secure rear
grass shield to LH side plate.
2
27 to 33 ft−lb
(37 to 44 N−m)
4
9
8
4
15 to 19 ft−lb
(20 to 25 N−m)
DPA Cutting Units