Toro Reelmaster 3100-D Service Manual page 277

Reel Bearing Installation Tool (cutting units with painted side plates)
Toro Part Number: 117−0975
Use the reel bearing installation tool to keep the reel
bearing aligned as the cutting unit side plate is installed
on the bearing.
Cutting Reel Shim
Toro Part Number: 125−5611
The cutting reel shim (0.002") is used to help parallel the
bedknife and cutting reel.
Cutting Performance Paper
Toro Part Number: 125−5610
Cutting performance paper is used to test the cutting
reel performance after adjusting the reel to bedknife
clearance. 10 packs (30 strips per pack) of cutting per-
formance paper are included in this part number.
Pulley Alignment Tool
Toro Part Number: 114−5446
Use pulley alignment tool to verify alignment of groomer
and/or rear roller brush drive and driven pulleys.
Reelmaster 3100−D Page 8 − 7
Figure 11
Figure 12
Figure 13
Figure 14
DPA Cutting Units