Hitachi Compute Blade 500 Series User Manual page 65

Description
Shows the following items of LP on a server blade.
• LP model
• Available LP firmware version
• License expiration date
• Performance tuning options
In SMP configuration
When you specify the primary server blade or a non-primary server blade,
LP settings of a specified server blade is shown. For a non-primary server
blade, LP settings are shown in parentheses.
Command: show blade hvm setting <server blade number>
When specifying -p parameter, specify the primary server blade to show
LP settings used in SMP configuration. The lowest level LP license among
all server blades in the configuration is used for operation. When you
specify a non-primary server blade, "-----" is shown as LP license.
Command: show blade hvm setting <primary server blade number> -p
Not in SMP configuration
Shows LP settings of a specified server blade. Even if -p parameter is
specified, the result is the same.
Role
Server Blade
Parameters
<blade_no>
Slot number of the server blade in the server chassis
Range is from 0 to 7.
Multiple selection is available.
If 'all' is specified for this parameter or this parameter is omitted, the
command shows all server blades.
-p
When you specify -p parameter, LP settings used for operation on all
server blades in SMP configuration are shown. Specify the primary server
blade in SMP configuration. Not in SMP configuration, LP settings of each
server blade are shown.
Omitting the -p parameter displays the license expiration date.
Specifying the -p parameter displays the Performance tuning options.
-v
Displays the model name by adding the internal ID to the model type of
LP license.
Hitachi Compute Blade 500 Series CLI Console User's Guide
CLI command
2-47