•
Sessions with management modules are disclosed after this command is
executed.
•
Do not use a console to change authentication information settings while
this command is running. In addition, do not perform operations for
management modules while this command is running because this
command restarts management modules.
•
This command can run only when the following conditions are met:
¢
¢
¢
¢
¢
¢
Network
show network vlan
Command
show network vlan -i <vlan_id> [-u0] [-u1]
Description
Shows the setting of VLAN in the management module.
Role
Network
Parameters
-i <vlan_id>
VLAN ID.
-u0
VLAN connected with MGMT0 port as untagged port.
-u1
VLAN connected with MGMT1 port as untagged port.
2-190
All installed server blades are powered off.
The firmware of all installed server blades is not being updated.
The firmware of management modules is not being updated.
Management module settings are not being restored.
Management modules are running normally.
The processing to enable or disable authentication encryption is not
being performed.
Range is from 1 to 4000
Not omissible.
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide