You execute this command to match the firmware version of the standby
management module to the firmware version of the active management
module, after you replaced the management module in a maintenance
operation. Do not use this command in usual operation.
Role
Chassis
Parameters
-F
Executes the command without inquiry.
Show items
None
Message
None
Example
[To synchronize the firmware of the active management module with the
firmware of the standby management module.]
$ sync mgmt-module firmware
W0036 : If confirm, standby management module will be restarted.
Confirm? (y/[n]):y
I0111 : <Management module> The management module has updated
successfully.
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
Under the following conditions, you cannot execute this command:
•
Only one management module is installed.
•
The standby management module is not placed in the BootDisable status.
•
The management module firmware and dictionary are currently being
updated.
sync mgmt-module fru
Command
sync mgmt-module fru [-F]
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-129