Example
[To display the port number for HTTP connections and the connection
permission settings for IPv4 and IPv6 addresses]
$ show remote-access protocol http
-- HTTP setting --
Port number
Allow
Network address
Subnet mask
-- HTTP setting (IPv6) --
Allow
Network address
Prefix len
S0002 : Command succeeded.
S0000 : Command was finished.
$
Comment
None
set remote-access protocol http
Command
set remote-access protocol http [-a <allow>] [-p <protocol_port>]
[-n <network_addr>] [-s <subnet_mask>] [-a6 <allow>] [-n6
<network_addr>] [-p6 <prefix_len>] [-F]
Description
Edits the setting of connection allowance of http.
You can change the following items:
(1) Port number for HTTP connections
(2) Connection permission settings for IPv4 addresses
¢
¢
(3) Connection permission settings for IPv6 addresses
¢
¢
If you omit a parameter, the corresponding settings will not be changed. If
you omit all parameters, the command will end normally without making any
changes.
: 81
: allow
: 192.168.0.0
: 255.255.255.0
: allow
: fe80::200:87ff:feb2:c24
: 64
Whether HTTP connections are permitted
Range of IP addresses to be permitted (network address and subnet
mask)
Whether HTTP connections are permitted
Range of IP addresses to be permitted (network address and prefix
length)
CLI command
Hitachi Compute Blade 500 Series CLI Console User's Guide
2-215