ABB IRC5 Product Manual page 117

Removal
The procedure below details how to remove the drive system power supply.
Refitting
The procedure below details how to refit the drive system power supply.
3HAC027707-001 Revision: D
Action
1.
DANGER!
Before any work inside the cabinet, please
observe the safety information in section
DANGER - Make sure that the main power
has been switched off! on page
2. Disconnect all connectors from the unit.
3. Loosen the attachment screws.
4. Pull the power supply unit to the right to
release it from the cap nuts, and remove it.
Action
1.
Danger
DANGER!
Before any repair work, please observe the
safety information in section
sure that the main power has been switched
off!.
4 Repair activities, controller IRC5
4.3.3. Replacement of drive system power supply
Note/Illustration
26.
B
xx0500001842
• A: drive system power supply
• B: cup nut (2 pcs)
• C: attachment screw (2 pcs)
Note/Illustration
DANGER - Make
Continued
A
C
Continues on next page
115