Intermittent Gear, 40 Removal - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C
7. Confirm that gears of "Intermittent Gear, 40" and "Release, Planetary Unit"
are not engaged. If they are engaged, release engagement by moving
"Release, Planetary Unit". (Refer to Figure 4-200.)
8. Rotate "Intermittent Gear, 40" in clockwise direction and look from the
opposite side of the frame to align the hook and cut-out.
(Refer to Figure 4-201.)
9. Remove "Intermittent Gear, 40" from printer body.
If "Intermittent Gear, 40" is difficult to remove, use tweezers
C H E C K
or a similar tool to push and remove "Intermittent Gear, 40"
P O I N T
by way of the hole on the opposite side of the frame. Be
careful not to scratch "Intermittent Gear, 40".
Install the "Intermittent Gear, 40" with its positioning rib
matched with the "Shaft, Release, Roller Driven" phase
position.
Rib
After installing "Intermittent Gear, 40" onto "Shaft,
Release, Roller Driven", turn it clockwise so the tab
faces downward.
Tab
Disassembly & Assembly
(Refer to Figure 4-201.)
Shaft, Release, Roller Driven
Phase
Disassembly Procedures
Intermittent Gear, 40
Release, Planetary Unit
Figure 4-200. Intermittent Gear, 40 Removal_1
Step 8
Step 9
Figure 4-201. Intermittent Gear, 40 Removal_2
Revision C
Release
engaged gears
Tab and Cutout
345