Harness, Head, Intermit / Harness, Head; Ffc Release; Release From Cover, Tube - Epson Stylus Pro 4400 Service Manual

EPSON Stylus Pro 4400/4450/4800/4880/4880C

4.2.8.11 Harness, Head, Intermit / Harness, Head

1. Remove the "Panel, Front".
(Refer to "4.2.3.5 Panel, Front/Panel Unit" (p219).)
2. Disconnect the "Harness, Head, Intermit" and the three "Harness, Head"s
from the following connectors on the "C593 SUB-D Board".
(Refer to "4.2.4.6 C593_SUB-D Board" (p240).)
CN4: Harness, Head, C
CN5: Harness, Head, A
CN6: Harness, Head, B
3. Remove the clamp that attaches the FFC to the printer frame at the front of
the printer. (Refer to Figure 4-174.)
4. Release the FFC from the tabs of the "Cover, Tube" and draw out the FFC
from the hole on the front frame of the printer.
5. Release the FFC from the tabs of the "Cover, Tube".
(Refer to Figure 4-176.)
Figure 4-174. FFC Release
Disassembly & Assembly
(Refer to Figure 4-175.)
Clamp
Disassembly Procedures
Figure 4-175. Release from Cover, Tube_1
Figure 4-176. Release from Cover, Tube_2
Revision C
Cover, Tube
331