Control Panel - Cub Cadet RZT-S Zero Shop Manual

Control panel

NOTE: The control panel is serviced as one assembly during the warranty period. Outside of warranty, the
individual controllers can be replaced.
NOTE: The contactor assembly is not serviceable and should not be opened. This would void the warranty.
Before disconnecting any electrical component, take precautions to prevent the component
! CAUTION ! CAUTION
or the wires attached to it from shorting out. The most effective means of doing this is to dis-
connect the positive lead of the battery pack from the contactor assembly.
IMPORTANT: Do not return an unsafe mower to service.
Figure 5.19
Positive lead
Contactor assembly
Figure 5.20
To remove/replace a control panel:
1. Disconnect the battery pack's positive lead from the
contactor assembly:
1a. Remove the three screws that hold the left
access cover in place using a 1/2" wrench.
See Figure 5.19.
1b. Disconnect the battery pack's positive lead from
the contactor assembly using a 7/16" wrench.
See Figure 5.20.
The battery pack's positive lead is
! CAUTION ! CAUTION
still hot. Take measures, such as
taping up the cable lug with electri-
cal tape, to prevent the cable end from making
contact with any metal surface on the mower
Electrical System
67