Cub Cadet RZT-S Zero Shop Manual page 147

Flange lock nuts
Figure 12
21. Install the batteries:
This mower has four batteries that need to be installed. They must be installed in a specific
order to minimize shorting hazards and to prevent improper wiring of the system.
! WARNING ! WARNING
Never let the battery terminals or any live harness connections contact the frame.
NOTE: The electrical system of this mower is a "floating" or "isolated" system. That means none of the electri-
cal components are grounded to the mower's frame.
NOTE: Before installing the batteries, remove the month and year from the label or write the date of installa-
tion on the side of the batteries with a magic marker. This will be helpful in diagnosing the batteries
after they have been in service for a while.
NOTE: Only use the nuts supplied with the batteries to attach the battery cables.
NOTE: The battery cables are color coded to assist in the installation of the batteries. There is colored tape to
identify the different cables. The protective boots that are on the ends of the cables are color coded red
for positive and black for negative.
2
The layout and numbering of the batteries.
4
1
3
Assembly Instruction Manual
20. Install the deck discharge chute deflector:
The discharge chute deflector must
! WARNING ! WARNING
be installed before operating the
mower. Never operate the mower
deck without the chute deflector installed and in
the down position.
20a. If attached, remove the ignition key from the
chute bracket.
20b. Remove the flange lock nuts from the deck. Do
not remove the push nuts or carriage bolts,
leaving them in place will aid in installing the
chute.
20c. Install the discharge chute deflector over the
carriage bolts. Install the flange lock nuts. See
Figure 12.
A5