Cub Cadet RZT-S Zero Shop Manual page 149

1
Figure 17
Battery tray
Figure 18
Green
2
Yellow
Figure 19
NOTE: Tighten the terminal nut to a torque of 10 - 15 ft lbs
Yellow tape
NOTE: The top and bottom battery trays are the same part
NOTE: The batteries should be standing on end, so that
3
Blue
NOTE: Tighten the terminal nuts to a torque of 10 - 15 ft
Assembly Instruction Manual
21e. Attach the wire with the yellow tape to the nega-
st
tive terminal of 1
(14 - 20 Nm).
21f. Attach bottom tray that holds rear batteries with
four self-taping screws from the hardware pack.
See Figure 18.
number.
21g. Remove the carrying handles from the two rear
batteries.
21h. Place the rear batteries in the bottom tray.
the terminals are next to each other.
See Figure 16.
21i. Attach the wire with the yellow tape (from the
st
1 battery) to the positive terminal of 2
tery. See Figure 19.
21j. Connect the jumper (green tape) across the two
top terminals of the 2
21k. Attach the wire with the blue tape to the nega-
rd
tive terminal of 3
lbs (14 - 20 Nm).
battery.
nd
bat-
nd rd
and 3 batteries.
battery.
A7