Cub Cadet RZT-S Zero Shop Manual page 124

RZT-S Zero
5. Remove the four black shoulder screws that secure
the front battery cover to the mower using a T-30
torx driver. See Figure 6.9.
6. Remove the front bracket: See Figure 6.10.
6a. Lower the mowing deck to its lowest setting.
6b. Remove the lock nuts from the carriage bolts
from the underside of the mower.
6c. Remove the three carriage bolts.
6d. Remove the four self tapping screws using a
1/2" wrench.
6e. Lift the front bracket over the two studs for the
seat bracket.
7. Slide the front battery out of the seat box assembly
enough to gain access to the battery cables.
See Figure 6.11.
8. Disconnect the wire with the blue tape from the pos-
itive terminal of the front battery.
NOTE: The battery cable with the blue tape is still
connected to battery number three. Take
measures to prevent the cable from contact-
ing the mower frame.
9. Disconnect the black wire from under left pod from
the negative terminal on front battery.
10. Lift the battery out of the mower.
11. The batteries weigh 63.5 lbs each.
120
Screws
Figure 6.9
Self tapping
screws
Carriage bolts
Figure 6.10
Blue
Black
Figure 6.11