Pos: 31.7.4 /DinA-4 -- Online/Applikations- / Parameterbeschreibungen -- (KNX)/Applikation/Objekt-RTR/ModuleAllgemein — Betriebsmodus nach Reset @ 40\mod_1421679113020_15.docx @ 312423 @ 3 @ 1

11.3.3

General - Operating mode after reset

Options:

After a reset the device will run in the operating mode after a restart until a new operating mode

is set as the result of device operation or by communication objects, as the case may be. This

operating mode should be defined during the planning phase. An improperly defined operating

mode can result in a loss of comfort or increased energy consumption.

–

Comfort: If the room temperature is not automatically lowered and the room is therefore

controlled independent of its use.

–

Standby: If the room is controlled automatically, e.g. by a presence detector, as a function of

its use.

–

Eco mode: If the room is controlled automatically or manually as a function of it use.

–

Frost/heat protection: If only the building protection function is necessary in the room after a

reset.

Note

This parameter is only available if the "Device function" parameter is set on

"Single device" or "Master device".

Pos: 31.7.5 /DinA-4 -- Online/Applikations- / Parameterbeschreibungen -- (KNX)/Applikation/Objekt-RTR/ModuleAllgemein — Zusätzliche Funktionen @ 40\mod_1421679254855_15.docx @ 312438 @ 3 @ 1

11.3.4

General - Additional functions

Options:

–

This parameter enables additional functions and communication objects, e.g. window

contact and presence detector.

Pos: 31.7.6 /Systemmodule/++++++++++++++ Seitenumbruch +++++++++++++++ @ 41\mod_1422789416992_0.docx @ 333487 @ @ 1

KNX Technical Reference Manual | 1473-1-8681

Description of applications /

Comfort

Standby

Eco mode

Cooling with additional stage

Frost/heat protection

Yes

objects

— 32 —

Table of Contents

General - Operating Mode After Reset; General - Additional Functions - ABB -i-Bus-KNX Millenium Reference Manual