Table of Contents
Advertisement
MYLOS
Building Automation
®
6.3.2
Operating mode
No.
Function
1
Frost/heat protection
This data item forms the 1-bit object of KNX for switching operating modes (frost and heat
protection). It can be received only.
For example, binary inputs that record information from window contacts to notify the ambient
temperature controller that a window is open or closed can send their current status to the
frost and heat protection object. When receiving an ON telegram, the room thermostat
activates frost protection mode; when an OFF telegram is received, frost protection mode is
deactivated and the current mode is changed.
The „window" symbol is shown in the display when frost/heat protection is enabled.
0: Frost/Heat Protection Off
1: Frost/Heat Protection On
2
Night mode
This 1-bit communication object can be used to switch the room thermostat to night mode
when an ON telegram is received. An OFF telegram deactivates night mode. This
communication object can be used, e.g., by time switches to send information.
This data item forms the 1-bit object of KNX for switching operating modes (night mode).
It can be received only, because a manual switch to night mode on site is not possible.
In night mode the parametrisable setpoint „night mode" is enabled and the fan stage is
limited to a parametrisable value.
0: night mode Off
1: night mode On
3
Comfort/standby mode
This 1-bit communication object can be used to switch the room thermostat to comfort mode
when an ON telegram is received. An OFF telegram deactivates comfort mode and activates standby mode. This
communication object can be used, e.g., by time switches to send information.
This data item forms the 1-bit object of KNX for switching operating modes (comfort/standby mode).
0: standby mode Off / comfort mode On
1: standby mode On / comfort mode Off
5
Auto mode
This 1-bit communication object can be used to switch the room thermostat to auto mode
when an ON telegram is received. An OFF telegram deactivates auto mode. This
communication object can be used, e.g., by time switches to send information.
This data item forms the 1-bit object of KNX for switching operating modes (auto mode).
0: auto mode Off
1: auto mode On
Commissioning
Object name
Type of datum
Operating mode
1 bit EIS1 DPT 1.001
Operating mode
1 bit EIS1 DPT 1.001
Operating mode
1 bit EIS1 DPT 1.001
Operating mode
1 bit EIS1 DPT 1.001
Flags
C,R,W
C,R,W
C,R,W
C,R,W
MYLOS
Building Automation | Commissioning 55
®
Advertisement
Table of Contents
