KNX Technical Reference Manual
®
ABB-i-Bus
-KNX Millenium
Pos: 31.7.64 /DinA-4 -- Online/Applikations- / Parameterbeschreibungen -- (KNX)/Applikation/Objekt-RTR/ModuleRegelung Zusatzstufe Kühlen — Erweiterte Einstellungen @ 40\mod_1421738257220_15.docx @ 313213 @ 3 @ 1
11.3.52
Control of additional cooling stage - Extended settings
Options:
This parameter enables additional functions and communication objects, e.g. "Additional cooling
stage".
Pos: 31.7.65 /DinA-4 -- Online/Applikations- / Parameterbeschreibungen -- (KNX)/Applikation/Objekt-RTR/Module/Zusatzstufe Kühlen @ 40\mod_1421738438512_15.docx @ 313228 @ 3 @ 1
11.3.53
Additional cooling stage
Note
Only available when the "Extended settings" parameter under "Control of
additional cooling stage" is set on "Yes".
Pos: 31.7.66 /DinA-4 -- Online/Applikations- / Parameterbeschreibungen -- (KNX)/Applikation/Objekt-RTR/Module/Zusatzstufe Kühlen — Wirksinn der Stellgröße @ 40\mod_1421738600834_15.docx @ 313243 @ 3 @ 1
11.3.54
Additional cooling stage - Mode of the control value
Options:
The mode of the control value can be used to adapt the control value to de-energised opened
(normal) or de-energised closed (inverse) valves.
–
Normal: Value 0 means "Valve closed".
–
Inverse: Value 0 means "Valve open".
Pos: 31.7.67 /DinA-4 -- Online/Applikations- / Parameterbeschreibungen -- (KNX)/Applikation/Objekt-RTR/Module/Zusatzstufe Kühlen — Hysterese (x 0,1°C) @ 40\mod_1421738707006_15.docx @ 313258 @ 3 @ 1
11.3.55
Additional cooling stage - Hysteresis (x 0.1°C)
Options:
The hysteresis of the two-point controller specifies the fluctuation range of the controller around
the setpoint value. The lower switching point is located at "Setpoint value minus hysteresis" and
the upper point is at "Setpoint value plus hysteresis".
Note
This parameter is only available when the "Control value type" parameter is set
either on "2-point 1 Bit, Off/On" or "2-point 1 Byte, 0/100%".
Pos: 31.7.68 /Systemmodule/++++++++++++++ Seitenumbruch +++++++++++++++ @ 41\mod_1422789416992_0.docx @ 333487 @ @ 1
KNX Technical Reference Manual | 1473-1-8681
Description of applications /
No
Yes
Normal
Inverse
Setting option between 3 - 255
objects
— 50 —