Swing Arm Bearing - Honda CH250 Elite 1986 Service Manual

REAR WHEEL/BRAKE/SUSPENSION
INSPECTION
WHEEL. RIM
therE~ar
wheel in a truing stand.
rear wheel by hand and measure the rim runout .using
a dial indicator.
SERVICE
LIMIT: AXIAL/RADIAL:
2.0
mm
(0.08
in)
SWING ARM BEARING
Turn the inner race of the bearing with your finger. The bearing
should turn smoothly and quietly. Also check that the bearing
outer race fits tightly in the swingarm.
Remove and discard the bearing if it does not turn smoothly,
quietly, or if outer race fits loosely in the swingarm.
BEARING REPLACEMENT
Attachment.
42 ){ 41
mm
Remove the
out.
TOOLS
Driver
from the swing.arm and drive the bearing
07149-0010000
or
07949-3110001
01146-0010300
Pack the new beluir:l(:l CiElvi1ties with grease and drjve it into the
swingarm using tools. as used to remOve the old
and install it over the
grease to the new dust seal
allow the bearing to tilt while drivll1g it In.
reirlstllil an old bearing. Once a bearing is removed. it
must be with a
15-3