Cisco 6921 Administration Manual page 94

Telephony Features Available for the Cisco Unified IP Phone
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description
Hold Reversion Limits the amount of time that a call can be on hold
before reverting back to the phone that put the call
on hold and alerting the user.
Reverting calls are distinguished from incoming
calls by a single ring (or beep, depending on the
new call indicator setting for the line). This
notification repeats at intervals if not resumed.
A call that triggers Hold Reversion also displays an
animated icon in the call bubble.
You can configure call focus priority to favor
incoming or reverting calls.
Hold Status Enables phones with a shared line to distinguish
between the local and remote lines that placed a
call on hold.
Hold/Resume Allows the user to move a connected call from an
active state to a held state.
HTTP Download Enhances the file download process to the phone to
use HTTP by default. If the HTTP download fails,
the phone reverts to using the TFTP download.
Hunt Group Provides load sharing for calls to a main directory
number. A hunt group contains a series of directory
numbers that can answer the incoming calls. When
the first directory number in the hunt group is busy,
the system hunts in a predetermined sequence for
the next available directory number in the group
and directs the call to that phone.
Intercom Allows users to place and receive intercom calls
using programmable phone buttons. You can
configure intercom line buttons to:
Note
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
5-10
Directly dial a specific intercom extension.
•
Initiate an intercom call and then prompt the
•
user to enter a valid intercom number.
If your user logs into the same phone on a
daily basis using their Cisco Extension
Mobility profile, assign the phone button
template that contains intercom
information to their profile, and assign the
phone as the default intercom device for
the intercom line.
Configuration Reference
For more information about configuring this
feature, see the Cisco Unified Communications
Manager Features and Services Guide,
Reversion.
No configuration is required.
Requires no configuration, unless you
•
want to use music on hold. See
"Music-on-Hold" in this table for
information.
• See "Hold Reversion" in this table.
No configuration is required.
For more information, see the following:
Cisco Communications Manager
•
Administration Guide,
Configuration.
• Cisco Unified Communications Manager
System Guide, Understanding Route
Plans.
For more information, see the Cisco Unified
Communications Manager Feature and
Services Guide, Intercom.
Chapter
Hold
Hunt Group
OL-24567-01