Cisco 6921 Administration Manual page 116

Setting up UCR 2008
•
•
•
Step 1 Choose Device > Device Settings > Common Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the SSH Access parameter to Disabled.
Step 4 Set the 80-bit SRTCP parameter to Enabled.
Click Save.
Step 5
Configuring UCR 2008 in Enterprise Phone Configuration
Use this procedure to set the following UCR 2008 parameters:
•
•
Step 1 Choose Device > Device Settings > Common Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the 80-bit SRTCP parameter to Enabled.
Step 4 Click Save.
Configuring UCR 2008 in Common Device Configuration
Use this procedure to set the following UCR 2008 parameters:
•
•
Step 1 Choose Device > Device Settings > Common Device Configuration.
Step 2 Set the IP Addressing Mode parameter.
Step 3 Set the IP Addressing Mode Preference for Signaling parameter.
Step 4 Click Save.
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
5-32
FIPS Mode
SSH Access
80-bit SRTCP
FIPS Mode
80-bit SRTCP
IP Addressing Mode
IP Addressing Mode Preference for Signaling
Chapter
OL-24567-01