Cisco 6921 Administration Manual page 115

Chapter
Table 5-5
Parameter
FIPS Mode
SSH Access
Web Access
80-bit SRTCP
IP Addressing Mode
IP Addressing Mode
Preference for
Signaling
Configuring UCR 2008 in Phone
Use this procedure to set the following UCR 2008 parameters:
•
•
Step 1 Choose Device > Phone.
Set the SSH Access parameter to Disabled.
Step 2
Set the Web Access parameter to Disabled.
Step 3
Click Save.
Step 4
Configuring UCR 2008 in Common Phone Profile
Use this procedure to set the following UCR 2008 parameters:
Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24567-01
UCR 2008 parameter location
Administration Path
Device > Device Settings > Common
Phone Profile
System > Enterprise Phone Configuration
Device > Phone
Device > Device Settings > Common
Phone Profile
Device > Phone
Device > Device Settings > Common
Phone Profile
System > Enterprise Phone Configuration
Device > Device Settings > Common
Device Configuration
Device > Device Settings > Common
Device Configuration
SSH Access
Web Access
Setting up UCR 2008
Procedure
Configuring UCR 2008 in
Common Phone Profile,
page 5-31
Configuring UCR 2008 in
Enterprise Phone Configuration,
page 5-32
Configuring UCR 2008 in Phone,
page 5-31
Configuring UCR 2008 in
Common Phone Profile,
page 5-31
Configuring UCR 2008 in Phone,
page 5-31
Configuring UCR 2008 in
Common Phone Profile,
page 5-31
Configuring UCR 2008 in
Enterprise Phone Configuration,
page 5-32
Configuring UCR 2008 in
Common Device Configuration,
page 5-32
Configuring UCR 2008 in
Common Device Configuration,
page 5-32
5-31