Factory Reset; Connecting To The Network Port; Figure 2-8 Factory Reset Switch; Figure 2-9 Network Connector - Honeywell HRSD40F User Manual

Factory Reset

The DVR has a Factory Reset switch to the left of the Network port on the rear panel.
Use this switch only on the rare occasion that you want to return all the settings to the
original factory settings.
Caution
To reset the unit, you will need a straightened paperclip:
1.
2.
3.
4.

Connecting to the Network Port

The DVR can be networked using the 10/100Mb Ethernet connector. Connect a CAT5
cable with an RJ45 jack to the DVR connector. The DVR can be networked with a
computer for remote monitoring, searching, configuration, and software upgrades. See
Chapter 3, Configuration
30
When you press Factory Reset, you will lose any settings you
have saved.
Figure 2-8
Turn off the DVR.
Poke the straightened paperclip into the unlabeled hole to the left of the Network
port (see Figure 2-8) and then turn on the DVR.
Hold the reset switch down until the DVR turns on and the live monitoring screen
appears.
Release the reset switch. All the DVR settings return to the original settings it had
when it left the factory.
Figure 2-9
N E T W O R K
Factory Reset Switch
Factory reset switch
for configuring the Ethernet connections.
Network Connector
HRSD40F DVR User Guide