Honeywell HRSD40F User Manual page 62

3.
4.
5.
6.
7.
62
Note You need to get the IP Address or domain name of the DVRNS
Server from your network administrator.
Note You can use the domain name instead of the IP address if you
have already set up the DNS Server during the LAN Setup.
Highlight the field beside Port and press
buttons to set the port number of the DVRNS server. The port number can be set
from 10000 to 12000.
Highlight the Use NAT field and press
Note When using the NAT (Network Address Translation) device, refer
to the NAT manufacturer's instructions for the proper network
settings.
Highlight the field beside DVR Name and press
name the DVR you want to register on the DVRNS server.
Highlight the Check field and press
have entered.
Note You must check the DVR name you enter by selecting Check
before you can save the DVRNS changes.
Note If you try to not enter a name, or if you try to enter a name that is
already registered on the DVRNS server, an error message
displays.
Highlight Save and press
have entered correct DVRNS settings, then the DVRNS server help desk
information displays in the field beside Help Desk.
. Use the Up and Down arrow
to toggle On and Off.
to check if you can use the name you
to register the DVR on the DVRNS server. If you
HRSD40F DVR User Guide
Use the virtual keyboard to