Check The Storage Capacity; Figure 18 Restore To Factory Default - Honeywell 35 Series Installation Manual

5. Login the NVR. Go to Setting > System > Maintenance.
6. Click on Reset and then select Restore to factory default.
7. Click YES to reset NVR.

Figure 18 Restore to Factory Default

Check the Storage Capacity

The below description is taking HN35080200 as an example.
Note:
1. Login NVR.
2. Go to Setting > Storage > Disk to check if the storage capacity is the same as the HDD
installed in the NVR.
Honeywell 35 Series NVR HDD Installation Guide
9