Timeout Retries
This setting limits the number of Communication Timeout retries. If
the Timeout Retries is set to 0, the transmission is terminated after the
initial Communication Timeout. Scan the bar code below, then set the
number of retries (from 0-255) by scanning digits from the
Programming
ting.) Default = 0.
Communication Timeout Beeper
This selection programs the scanner to issue an error beep when a
communication timeout has occurred. The error beep sound is pro-
grammed using
NAK Retries
This selection limits the number of NAK retries that can occur in ACK/NAK
mode. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the
(5 is the recommended setting.) Default = 0, or disabled.
2 - 24
Chart, then scanning Save. (5 is the recommended set-
Timeout Retries
Number of Beeps – Error
Programming
NAK Retries
(page 4-4). Default = On.
* On
Chart, then scanning Save.