Scanner Power Time-Out Timer; Batch Mode - Honeywell Voyager 1200g User Manual

Scanner Power Time-Out Timer

Note: Scanner Power Time-out Timer only applies to cordless systems. It does
not apply to corded scanners.
When there is no activity within a specified time period, the scanner enters low
power mode. Scan the appropriate scanner power time-out bar code to change
the time-out duration (in seconds).
If the scanner is not activated during the timer interval, the scanner goes into
power down mode. Whenever the scanner is activated, the timer is reset. If
Scanning While in Base Cradle
into power down mode. Default = 3600 seconds.
Timer Off
400 seconds
* 3600 seconds
Note: When the scanner is in power down mode, press the scanner's button to
power the unit back up. There will be a set of power up beeps and a delay
of up to a few seconds for the radio to join. The scanner will then be ready
to use.

Batch Mode

Batch mode is used to store bar code data when a scanner is out of range of its
base, or when performing inventory. The data is transmitted to the base once
the scanner is back in range or when the records are manually transmitted.
(page 3-8) is disabled, the scanner will still go
200 seconds
900 seconds
7200 seconds
3 - 13