In-Stand And Out-Of-Stand Defaults; Presentation Modes - Honeywell Voyager 1200g User Manual

In-Stand and Out-of-Stand Defaults

If you want the In-Stand or Out-of-Stand default settings restored to your
scanner, scan the appropriate Defaults bar code below. They reset the
scanner to the custom default settings (see
page 1-8). If there are no custom defaults, it will reset the scanner to the
factory default settings. Any settings that have not been specified through
the custom defaults will be defaulted to the factory default settings.
In-Stand Defaults

Presentation Modes

When the scanner is in the stand, by default, bar codes are automatically
read when they are detected in the scanner's field of view. When the scan-
ner is out of the stand, by default you must push the button on top of the
scanner to read a bar code. Use the following commands to adjust how the
scanner behaves when it is out of the stand.
Note: If you are using a cordless charge base in Presentation Mode, the
battery will not charge unless the power supply is plugged into the
base's auxiliary power port.
Presentation Mode Out-of-Stand: When the scanner is not in the stand,
it automatically detects bar codes, then scans and transmits the data. The
laser turns off afterward. (If you are accustomed to a Voyager 9520, this
setting is the same as the 9520's default.)
Presentation Mode with CodeGate® Out-of-Stand: When the scanner
is not in the stand, it automatically detects bar codes and decodes them.
However, the data is not transmitted until you press the button. The laser
remains on briefly after the transmission. (If you are accustomed to a Voy-
ager 9540, this setting is the same as the 9540's default.)
Presentation Mode
Out-of-Stand
Setting Custom Defaults
Out-of-Stand Defaults
Presentation Mode with
CodeGate Out-of-Stand
on
4 - 9