Batch Mode Transmit Delay; Scanner Name - Honeywell Voyager 1200g User Manual

Batch Mode Transmit Delay

Sometimes when accumulated scans are sent to the host system, the
transmission of those scans is too fast for the application to process. To
program a transmit delay between accumulated scans, scan one of the fol-
lowing delays. Default = Off.
Note: In most cases, a short (250 ms (milliseconds)) delay is ideal,
however, longer delays may be programmed. Contact Technical
Support
* Batch Mode Transmit Delay Off
(No Delay)
Batch Mode Transmit Delay Medium

Scanner Name

You may assign a name to each scanner you are using for identification pur-
poses. The default name is "Voyager."
Perform the rename operation using either the bar codes on
sending the serial command :Voyager:BT_NAM name . where name is the new
name for the scanner. If you wish to change the names of additional scanners,
link them to the base one at a time and repeat the :Voyager:BT_NAM name .
command for each scanner.
3 - 20
(page 13-2) for additional information.
(500 ms)
Batch Mode Transmit Delay Short
(250 ms)
Batch Mode Transmit Delay Long
(1000 ms)
page 3-21, or by