Character Deactivation Mode; Deactivation Character - Honeywell Voyager 1200g User Manual

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the fol-
lowing On bar code to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to termi-
nate scanning. Default = Off.
* Off

Deactivation Character

This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
1252), page A-4, find the hex value that represents the character you want
to use to terminate scanning. Scan the following bar code, then use the
Programming Chart
that ASCII character. Scan
4 - 16
ASCII Conversion Chart (Code Page
to read the alphanumeric combination that represents
Save to finish.
Deactivation Character
On