Table of Contents
Advertisement
Warnings
Installation and servicing should be performed only by qualified and experienced
personnel.
Power off the encoder when connecting cameras, audio, or sensor cables.
The manufacturer is not responsible for any damage caused by improper use of
the product or failure to follow instructions for the product.
The manufacturer is not responsible for any problems caused by or resulting
from the user physically opening the encoder for examination or attempting to fix
the unit. The manufacturer may not be held liable for any issues with the unit if the
warranty seal is removed.
Cautions
This product has multiple-rated voltages (110V and 240V). See installation
instructions before connecting to the power supply.
This product uses a Lithium battery. To avoid a risk of explosion, do not replace
the battery on the main board by anything other than a Lithium battery. Dispose
of used batteries according to the manufacturer's instructions.
This equipment and all communication wirings are intended for indoor use only. To
reduce the risk of fire or electric shock, do not expose the unit to rain or moisture.
WEEE (Waste Electrical and Electronic
Equipment)
Electromagnetic Compatibility (EMC)
The product must be installed and maintained in accordance with good
installation practice to enable the product to function as intended and to prevent
problems. Refer to Honeywell Video Systems for installation guidance.
The manufacturer declares that the equipment supplied with this guide is
compliant with the essential protection requirements of the EMC directive
89/336/EEC and the Low Voltage Directive LVD 73/23 EEC, conforming to the
requirements of standards EN 55022 for emissions and EN 50130-4 for immunity.
Rev 1.04
Customers in European Union countries are advised to
dispose of this product, at the end of its useful life, as per
applicable local laws, regulations and procedures.
vi
Document 900.0572
09/06
Advertisement
Table of Contents
