Figure 2-26 Select Ptz Channel Model - Honeywell HNVE130A User Manual

Figure 2-26
6. Select the PTZ protocol from the drop-down list. See
complete list of the PTZ protocols supported.
7. Set the Channel ID (Rx Address) to the same as the camera address set on
the dome.
8. Click OK to register the selection.
9. Click Logout to exit the setup screen.
Once the HNVE130A has been configured for PTZ operation, verify that the PTZ
RS485 control outputs on the rear of the module are connected to the PTZ
camera according to the instructions in the PTZ Installation Manual (see
Figure 1-1 for location of PTZ control outputs). Refer to the following table or the
Installation Guide for your PTZ camera to determine the correct baud rate,
number of stop bits and parity for the particular PTZ protocol you have selected.
Field
Baud Rate
Data Bits
Parity
Stop Bits
Verify that the HNVE130A is correctly connected and able to control the PTZ
camera by re-connecting to the HNVE130A web interface to view live images.
Rev 1.04
Select PTZ Channel Model
Pelco P
B2400
8
None
1
Pelco D
B2400
8
None
1
28
Figure 2-26 for a
Scandome2d
B9600
8
None
1
Document 900.0572
09/06