Control The Wireless Radio - NETGEAR N600 JNDR3000 User Manual

N600 wireless dual band router
Table of Contents

Advertisement

Enable 20/40 MHz Coexistence. This applies only to the 2.4 GHz band. The 20/40 MHz
coexistence function is enabled by default when the wireless mode is set to Up to 300 mbps
(40 MHZ), which is required for Wi-Fi certification. This check box is grayed out if the wireless
mode is set to Up to 130 Mbps.
The router can run in either 40 MHz mode or 20 MHz mode when the wireless mode is set to
Up to 300 Mbps. When the Enable 20/40 MHz Coexistence check box is selected, the router
runs in 40 MHz mode unless there is another nearby WiFi network in the area already
running in 40 MHz mode or there is a wireless access point on the secondary channel. If that
happens, the router runs in 20 MHz mode to coexist with that network.
If you want the router to always run in 40 MHz mode, clear this check box and click the Apply
button.
Note:
The Fragmentation Length, CTS/RTS Threshold, and Preamble
Mode options are reserved for wireless testing and advanced
configuration only. Do not change these settings.
Turn off wireless signal by schedule. Select this check box to turn off the wireless signal
from your router at times when you do not need a wireless connection. For example, you
could turn it off for the weekend if you leave town.
WPS Settings. You can add WPS devices to your network.
AP Mode. Select the Enable AP Mode check box to make the router function as an access
point.
Wireless Card Access List. Click the Set Up Access List button to display the Wireless
Card Access List screen. On this screen, you can restrict access to your network to specific
devices based on their MAC address.

Control the Wireless Radio

By default, the wireless radio is enabled so that you can connect wirelessly to the router. You
can turn the wireless radio on or off in the Advanced Wireless Settings screen or by using the
WiFi On/Off button on the router side panel. When the wireless radio is off, you can still use
an Ethernet cable for a LAN connection to the router.
N600 Wireless Dual Band Router JNDR3000
Advanced Settings
89

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jndr3000

Table of Contents