NETGEAR N600 JNDR3000 User Manual page 27

• Internet Service Provider. ISP types. The choices are PPPoE, PPTP, and L2TP.
• Login. The login name provided by your ISP. The login name is usually an email address.
• Password. The password that you use to log in to your ISP.
• Service Name (If Required). If your ISP provided a service name, enter it here.
Otherwise, you can leave this field blank.
• Connection Mode. The choices are Always On, Dial on Demand, or Manually Connect.
This specifies when the router should establish the PPPoE connection. The default
connection mode is Always On to provide a steady connection. The router never
disconnects the connection, and in case the connection is broken (such as if the modem
is turned off), the router establishes the connection right after the PPPoE connection is
available.
• Idle Timeout (In minutes). If you want to change the login time-out, enter a new value in
minutes. This value determines how long the router keeps the Internet connection active
after there is no Internet activity from the LAN. Entering a value of 0 (zero) means never
log out.
Internet IP Address.
• Get Dynamically from ISP. Your ISP uses DHCP to assign your IP address. Your ISP
automatically assigns these addresses.
• Use Static IP Address. Enter the IP address, IP subnet mask, and the gateway IP
address that your ISP assigned. The gateway is the ISP router to which your router
connects.
Domain Name Server (DNS) Address. The DNS server is used to look up site addresses
based on their names.
• Get Automatically from ISP. Your ISP uses DHCP to assign your DNS servers. Your ISP
automatically assigns this address.
• Use These DNS Servers. If you know that your ISP does not automatically transmit DNS
addresses to the router during login, select this option, and enter the IP address of your
ISP primary DNS server. If a secondary DNS server address is available, enter it also.
Router MAC Address. The Ethernet MAC address used by the router on the Internet port.
Some ISPs register the MAC address of the network interface card in your computer when
your account is first opened. They accept traffic only from the MAC address of that computer.
This feature allows your router to use your computer's MAC address (this is also called
cloning).
• Use Default Address. Use the default MAC address.
• Use Computer MAC Address. The router captures and uses the MAC address of the
computer that you are now using. You have to use the one computer allowed by the ISP.
• Use This MAC Address. Enter the MAC address that you want to use.
N600 Wireless Dual Band Router JNDR3000
NETGEAR genie Basic Settings
27