Table of Contents
Advertisement
Back Panel
The back panel has the button and port connections shown in the following figure.
Figure 3. Back panel connections and buttons
For a list of the default settings, see
N600 Wireless Dual Band Router JNDR3000
USB 2.0 port
Restore Factory Settings button. Press and hold this button for
about five seconds to reset the router to its factory default
settings.
Four local area networks (LAN) 10/100 Mbps Ethernet
ports for connecting the router to your local computers.
Internet/Wide Area Network (WAN) Ethernet port for connecting
the router to a cable or DSL modem.
AC power adapter outlet for connecting the power adapter.
Power On/Off button
Factory Settings
Hardware Setup
13
on page 128.
Advertisement
Table of Contents
